Opex Sure Sort Traduction Des Instructions Originales page 300

5.3.2. Jams
The .csv file will only display jams that occurred during the selected time range
in your report. The following is a list of all possible jams.
Jam message
Charging rail
sensor(s) blocked
Critically low iBOT
power
Critical Message
Failure
ELC
Communication
Error
150
Description
Each charging rail in the machine (except the one on
the main door) has sensors behind it to detect if the
rail is extended or retracted. The Real-Time Controller
calls a jam if the extended sensor or retracted sensor
is blocked when it should not be. The extended
sensor will be blocked when the machine is in an idle
or stopped state and the iBOTs are parked. It will be in
a retracted state when the machine is running and the
iBOTs are moving through the column.
Occurs when the Real-Time Controller detects that
the power level of an iBOT is too low to deliver the
piece, as it does not have enough power to spin the
conveyor and then return to the charge rail.
Occurs when the Real-Time Controller has not
received confirmation that the iBOT has received a
critical message. This occurs when the iBOT is
approaching the loading point.
caused when the Host application loses
communication with the External Link Component
(ELC).
Loss of communication with the ELC can result in one
or more critical messages being lost by the Host
application or the ELC, and they may now have
conflicting data about pieces in the system. Therefore,
the job is not allowed to proceed even if
communication can be reestablished with the ELC.
The correct disposition of pieces that are in the
system, but not yet delivered, needs to be determined.
Sure Sort™ Operator Manual
OPEX Corporation
Statistics