Child Seat Functions; Using The Lower Universal Anchorage System (Luas); Using The Lower Connectors; Using The Energy Absorbing Versa-Tether - Britax Pavilion 65-G3 Guide D'utilisation

Child Seat Functions

Using the Lower Universal Anchor System (LUAS)
The Lower Universal Anchor System or LUAS, is a system available on this
child seat that offers an alternative to vehicle seat belt installation methods.
See pages 10 and 11 for LUAS components on this child seat.
The figure above shows typical locations for lower anchors and tether
anchors in a vehicle. Check your vehicle owner's manual to learn if it is
equipped with LUAS, the maximum weight rating for the lower anchors, and
for information on the lower anchor locations and seating positions available
for use with this child seat.
Standard vehicle seat spacing between LUAS anchors is 27.9 cm (11 in.)
This child seat can be used in a seating position with up to 50.8 cm (20 in.)
of space between the LUAS anchors if the vehicle manufacturer allows.
WARNING!
In some cases, the vehicle
head restraint can prevent the child seat head pad
from being raised high enough to properly adjust
the harness for the fit of your child when using a
forward facing reclined position. DO NOT force the
child seat head pad past the vehicle head restraint.
Doing so could cause the child seat not to perform
as intended. If the location of the vehicle head
restraint interferes with the child seat head pad,
raise or remove the vehicle head restraint. If the vehicle head restraint
cannot be removed, move the child seat to the upright position or try a
different seating location.
16

Using the Lower Connectors

Where to find the Lower Connectors
The lower connectors are located in the back of the base of the child seat.
Store the connectors in the slots when not in use.
To remove the lower connector from the storage slot or lower
anchor:
1 Press and hold the red release
button.
2 Pull the lower connector from the
storage slot or lower anchor.
To attach the lower connector to the storage slot or lower
anchor:
Firmly push the lower connector into
the slot or lower anchor until a click is
heard.
NOTE: The lower connectors store top
down in the slots.

Using the Energy Absorbing Versa-Tether

WARNING! Failure to follow the guidelines below may
cause the child seat not to perform as intended:
• You MUST always use the Versa-Tether when using the
child seat forward-facing. Using the tether will improve the
stability of your child seat and reduce the risk of injury.
• Attach the Versa-Tether only to tether anchors identified by
your vehicle manufacturer as tether anchorage points. Only
use the designated tether anchor for each seating position.
• If your vehicle does not currently have a tether anchor
attachment, refer to your vehicle owner's manual or contact
your vehicle man u fac tur er for assistance. DO NOT modify
your vehicle without advice from your vehicle manufacturer.
• Store the Versa-Tether in the pouch on the back of the child
seat when not in use. DO NOT install the child seat with the
Versa-Tether attached to the carry clip.
Child Seat Functions
Top
®
17