Maintenance Of Cutting Table; Maintenance Of Cut-Off Wheels; Storing Bakelite Bonded Al; Cut-Off Wheels - Struers Discotom-50 Manuel D'instructions

Maintenance of Cutting Table

Maintenance of Cut-off Wheels

Storing Bakelite Bonded Al

Cut-off Wheels

Maintenance of Diamond and
CBN Cut-off Wheels
Maintenance of
Clamping Devices
30
Discotom-50
Instruction Manual
The stainless steel bands are available as spare parts and should
be replaced if they become worn or damaged.
O Bakelite bonded cut-off wheels are sensitive to humidity.
2 3
Therefore, do not mix new, dry cut-off wheels with used humid
ones. Store the cut-off wheels in a dry place, horizontally on a
plane support.
The precision of diamond and CBN cut-off wheels (and thus the
quality of the cut) depends on how carefully the following
instructions are observed:
Never expose the cut-off wheel to a heavy mechanical load, or
heat.
Store the cut-off wheel in a dry place, horizontally on a plane
support, preferably under light pressure.
A clean and dry cut-off wheel does not corrode. Therefore, clean
and dry the cut-off wheel before storing. If possible, use
ordinary detergents for the cleaning.
Regular dressing of the cut-off wheel is also part of the general
maintenance.
It is recommended to thoroughly clean and lubricate the
Quick Clamping Device and Vertical Clamping Device at regular intervals.
Important