Maintenance Of Cut-Off Wheels; Storing Bakelite Bonded Al; Cut-Off Wheels; Maintenance Of Diamond And Cbn Cut-Off Wheels - Struers Discotom-6 Mode D'emploi

Maintenance of Cut-off Wheels

Storing Bakelite Bonded Al

Cut-off Wheels

Maintenance of Diamond and
CBN Cut-off Wheels
Maintenance of
Clamping Devices
28
Discotom-6
Instruction Manual
These cut-off wheels are sensitive to humidity. Therefore, do not mix
new, dry cut-off wheels with used humid ones. Store the cut-off
O
2 3
wheels in a dry place, horizontally on a plane support.
The precision of diamond and CBN cut-off wheels (and thus the cut)
depends on how carefully the following instructions are observed:

Never expose the cut-off wheel to a heavy mechanical load, or
heat.

Store the cut-off wheel in a dry place, horizontally on a plane
support, preferably under light pressure.

A clean and dry cut-off wheel does not corrode. Therefore, clean
and dry the cut-off wheel before storing. If possible, use ordinary
detergents for the cleaning.

Regular dressing of the cut-off wheel is also part of the general
maintenance.
It is recommended to thoroughly clean and lubricate the
Important
Quick Clamping Devices at regular intervals.