Harsh Enclosure - Mettler Toledo IND780 Guide D'installation

2.2.2.

Harsh Enclosure

The front panel of the harsh enclosure IND780 terminal is locked in place by four spring clips
attached to the enclosure body. To gain access to the terminal's PCB for internal wiring and setting
switches, separate the front panel from the enclosure as follows:
1. Place the terminal on a stable, flat surface, with its front panel facing up.
2. Insert the tip of a flat blade screwdriver into one of the two slots located on the edge of the front
3. Repeat Step 2 for the other slot, freeing the bottom of the cover from the spring retaining clips.
64057253 | 14 | 08/2014
Figure 2-1: Opening the Panel Mount Enclosure
Figure 2-2: Opening the Harsh Enclosure
panel assembly (see Figure 2-2). Squeeze the top of the front panel firmly down against the
enclosure, in order to relieve the pressure on the retaining clip, and push the screwdriver in
toward the enclosure until a "pop" sound is heard.
METTLER TOLEDO IND780 Installation Guide
2-3