Desktop Mounting; Preparation For Wall Mounting - Mettler Toledo IND780 Guide D'installation

2.3.2.1.

Desktop Mounting

If the IND780 terminal is to be placed on a flat surface, the four rubber feet included with the
terminal should be adhered to the bottom of the enclosure to prevent sliding. Peel each foot from
the protective paper and press it onto one corner of the bottom of the enclosure, as shown in Figure
2-6.
2.3.2.2.

Preparation for Wall Mounting

An optional wall bracket kit is available for wall mounting the IND780 harsh enclosure to a vertical
surface. To prepare the enclosure for wall mounting, follow these steps:
1. Establish orientation of enclosure (above or below eye level)
2. Install enclosure on brackets
3. Mark attachment points
4. Install mounting hardware
5. Mount terminal hardware
2-6
METTLER TOLEDO IND780 Installation Guide
Figure 2-6: Rubber Feet for Desktop Mounting
64057253 | 14 | 08/2014