Installation; Opening The Enclosure - Mettler Toledo IND256 Série Guide D'installation

2.

Installation

2.1.

Opening the Enclosure

Open IND256x terminal according to the steps in the following sections.
The front cover of the IND256x terminal is attached by 4 screws. For hardware configuration inside
the instrument, open it as shown below:
1. Place the terminal face-down on a flat surface, taking care not to damage the fascia.
2. Unscrew the four captive screws indicated in Figure 2-1.
30491430 | 06 | 09/2020
DO NOT INSTALL OR PERFORM ANY SERVICE ON THIS EQUIPMENT BEFORE THE AREA HAS
BEEN SECURED AS NON-HAZARDOUS BY PERSONNEL AUTHORIZED TO DO SO BY THE
RESPONSIBLE PERSON AT THE CUSTOMER'S SITE.
CONFIRM COMPLIANCE WITH APPLICABLE NATIONAL AND LOCAL WIFI REGULATIONS
BEFORE INSTALLING AND COMMISSIONING IND256x TERMINAL CONFIGURED WITH WIFI
MODULE. METTLER TOLEDO ACCEPTS NO RESPONSIBILITY FOR TERMINAL INSTALLATION IN
COUNTRIES WHERE WIFI REGULATIONS ARE NOT FULFILLED. PRODUCT WIFI APPROVALS
CAN BE FOUND AT http://glo.mt.com/global/en/home/search/compliance.html/compliance/.
TO PREVENT IGNITION OF HAZARDOUS GAS, BE SURE TO CUT OFF THE POWER BEFORE
OPENING IND256X ENCLOSURE. AFTER IND256X IS POWERED ON, KEEP THE ENCLOSURE
STRICTLY SEALED. DO NOT OPEN THE CASE IN THE PRESENCE OF EXPLOSIVE DUST OR GAS.
Figure 2-1: Enclosure screws
METTLER TOLEDO IND256x Weighing Terminal Installation Manual
WARNING
CAUTION
WARNING
2-1