Harsh Enclosure Sealing - Mettler Toledo IND780 Guide D'installation

6. Remove most of the slack from the wire, then loop it once around the seal, as shown in Figure
7. Finally, snap the seal shut and trim off the excess wire.
2.9.2.

Harsh Enclosure Sealing

For external sealing of the harsh enclosure, refer to Figure 2-116 and follow these steps:
2-68
METTLER TOLEDO IND780 Installation Guide
Figure 2-111: Sealing Wire Installed, Wire Threaded Through Seal
2-112.
Screw securing
upper card guide
Plastic seal
Figure 2-113: 3-Point Sealing, Panel Enclosure Rear Cover
Figure 2-112: Wire Looped Around Seal
Rear panel
mounting screws
with sealing wire
64057253 | 14 | 08/2014