Controlnet Interface - Mettler Toledo IND780 Guide D'installation

Figure 2-92 shows the RIO PLC interface module, with its connector at upper right.
2.8.3.

ControlNet Interface

The ControlNet PLC Module (Figure 2-93) connects to the ControlNet network via one or two
coaxial cables (Figure 2-95). Channel B is redundant with Channel A, and is not used unless
ControlNet detects no signal on Channel A. Note that the module's address is set in software, and
the MAC ID switches indicated in Figure 2-93 are not used.
2-60
METTLER TOLEDO IND780 Installation Guide
Figure 2-92: Allen Bradley RIO PLC Interface Module
RJ-45 for Diagnostics
and Configuration
Channel A
Figure 2-93: ControlNet PLC Module Connections and Components
Do not plug an Ethernet cable into the RJ-45 connector shown at left in Figure 2-93. Damage
to the IND780 may result.
MAC ID Switches (not used)
Channel B
LED Array
64057253 | 14 | 08/2014