MSA Altair 5X Mode D'emploi page 44

Setting Sensor Options
1. Press the
• The following screen displays:
2. Press the ▼ button to select sensor and the
make changes.
• The sensor information is displayed, and the sensor can be
enabled or disabled.
NOTE: Other operations such as changing the gas type (Methane,
Butane, Propane, etc. for the combustible sensor) and
units (ppm to mg/m
MSA Link software.
3. Change status by pressing the ▼ or ▲ button.
4. Press the
(next sensor).
5. Perform the sequence for all other sensors
• After setting up the last sensor, the instrument
goes to the next SETUP page.
Language
This option is for setting the language of the instrument.
1. Press button to enter Setup.
2. Change language by pressing the ▼ or ▲ button.
3. Confirm by pressing the
• The instrument goes to the next SETUP page.
button to enter setup.
Figure 3-8. Sensor Options
3
button to confirm and advance to the next screen
button.
) are only possible using the
button to
3-13