Force Reduction - Struers RotoForce-3 Mode D'emploi

16
RotoForce-3
Instruction Manual

1. Force Reduction

RotoForce-3 is equipped with the possibility of automatic
reduction of the force towards the end of the preparation.
If FORCE REDUCTION is enabled, the force will automatically
be reduced from the actual value down to 5 N during the last 30
seconds of the preparation step. This will result in lower material
removal and smaller scratches than usual. The time for the
subsequent preparation steps can be reduced as the amount of
damaged material to be removed will be reduced.
1500N 04:00
STOP
,
m
,
FORCE REDUCTION
NO
, 7
L L
, 7
FORCE REDUCTION
YES
,
o
,
150N 04:00
STOP
m
Press MENU until you reach the
FORCE REDUCTION screen.
L
Press SELECT to toggle between
NO and YES.
o
Press STOP to accept the choice.
Operation Menu will appear again.