Electrical Control Unit; Maintenance, Cleaning; Safety Instructions - Burkert 2300 Manuel D'utilisation

Electrical control unit

9 elecTrical cOnTrOl uniT
The valve Type 2300 can be combined with following control units:
• Type 8692 Positioner
• Type 8694 Positioner
• Type 8696 Positioner
• Type 8693 Process controller
The electrical connection of the pilot valve or the control
unit is described in the respective operating instructions for
the pilot valve/control unit in the chapter titled "Installation".
Type 2300
10 mainTenance, cleaning
10.1 safety instructions
Danger!
danger – high pressure in the equipment!
▶ Before loosening the lines and valves, turn off the pressure and
vent the lines.
risk of injury due to electrical shock!
▶ Before reaching into the system, switch off the power supply
and secure to prevent reactivation!
▶ Observe applicable accident prevention and safety regulations
for electrical equipment!
Warning!
risk of injury from improper maintenance!
▶ Maintenance may be performed by authorised technicians only!
▶ To screw on or unscrew valve body or actuator, use an open-
end wrench, never a pipe wrench, and observe tightening
torques.
risk of injury from unintentional activation of the system and
an uncontrolled restart!
▶ Secure system from unintentional activation.
▶ Following maintenance, ensure a controlled restart.
english
29