Washing Supply Connection; Connecting The Burnt Gas Exhaust Vent - Angelo Po FX 201 G3 Manuel D'utilisation Et D'installation

WASHING SUPPLY CONNECTION

To carry out this operation, proceed as follows.
1 – Connect the red pipe (A) to the pipe (B) and fit the
cone (C) into the cleaner tank (D).
2 – Connect the blue pipe (E) to the pipe (B) and fit
the cone (C) into the sanitizing cleaner tank (F).
Use the cleaner and sanitizing supplied by the oven
manufacturer for the best results.
The chemical composition of the products referred to
above is as follows:
Cleaner: caustic soda, concentration less than 20%.
Sanitizing cleaner: containing citrates and organic
sequestering agents, less than 15%.
Important
The use of products with different compositions
may damage the system and the oven walls, and
any residues deposited may contaminate foods.

CONNECTING THE BURNT GAS EXHAUST VENT

Important
Make the connection in compliance with the relevant legal requirements, using
appropriate and recommended materials.
Important
The maximum exhaust gas temperature at the
outlet is about 400°C.
Connecting to a fan extractor hood
Position the appliance underneath the hood (C) as
shown in the diagram.
Important
The fan of the extraction system must switch on
automatically when the gas supply tap is turned
on.
English
B
C
C
min
0,3m
- 57 -
A
E
F
D
IDM-39619201100.tif
IDM-39619300700.tif
Use and installation manual
IT
GB
DE
FR
ES