Water Connection - Angelo Po FX 61 E 1-2 Manuel D'utilisation Et D'installation

WATER CONNECTION

Caution - warning
Make the connection in compliance with the relevant legal requirements, using
appropriate and recommended materials.
Water supply connection
Connect the mains line to the appliance's connection
pipe, fitting a shut-off tap (B) to allow the water supply
to be cut off when necessary.
Important
The tap (B), not supplied with the appliance, must
be installed in an easily accessible position and
its status (on or off) must be obvious at a glance.
Caution - warning
The appliance must be supplied with drinking wa-
ter having the characteristics shown in the table.
If these characteristics are not complied with the
appliance might suffer damage; a water treat-
ment device should therefore be installed.
Description
Pressure
Water flow rate (l/h)
pH
Conductivity
Hardness
Salt and metallic ion content
Chlorine
Chlorides
Sulphates
Iron
Copper
Manganese
(*) The value refers to the amount of water needed for steam production inside the cooking chamber.
Important
For the United Kingdom only, also see instructions provided in the enclosure.
(see "Water connection (WRAS)").
English
B
Value
200÷400 kPa (2÷ 4 bar) (*)
9 l/h (FX 61) (*)
12 l/h (FX 101) (*)
7÷7.5
< 200µS/cm
9÷13°f (5÷7°d, 6.3÷8.8°e, 90÷125 ppm)
<0,1 mg/l
< 30 mg/l
< 40 mg/l
< 0,1 mg/l
< 0.05 mg/l
< 0,05 mg/l
- 25 -
IDM-39617701300.tif
Use and installation manual
IT
GB
DE
FR
ES