Replacement Of The Burner Nozzle; Replacing The Fuse - Angelo Po FX 201 G3 Manuel D'utilisation Et D'installation

REPLACEMENT OF THE BURNER NOZZLE

To carry out this operation, proceed as follows.
1 – Undo the screws to remove the side panel (A).
2 – Disconnect the gas supply line (B).
3 – Remove the injector (C) and replace it with the one suitable for the type of gas in
use (see table at back of manual).
Important
Take care to ensure that the nozzle (C) is correctly positioned (see diagram).
4 – Reconnect the pipe (B), replace the panel (A) and retighten the screws when the
operation is complete.

REPLACING THE FUSE

To carry out this operation, proceed as follows.
1 – Undo the screws to remove the side panel (A).
2 – Open the fuse-holder (B) and replace the damaged fuse (C).
3 – Replace the fuse-holder and the side panel when the operation is complete.
English
A
B
C
B
- 61 -
C
C
A
IDM-39619201700.tif
IDM-39619301100.tif
Use and installation manual
IT
GB
DE
FR
ES