Alarm
Fault
E07
Power board failure
The optional vacuum probe has
E08
failed or is not properly connect-
ed
Electrical component compart-
E10
ment has overheated
E11
Electronic circuit board diag-
E13
nostics tripped
E14
The humidity probe has failed or
E19
is not properly connected
E20
Setup error
The washing cycle has been in-
E21
terrupted because there is no
cleaner
The washing cycle has been in-
IT
E22
terrupted because there is no
sanitizing cleaner
GB
DE
FR
The washing cycle has been in-
ES
E23
terrupted during the final saniti-
zation stage
Automatic cleaning system fail-
E24
E26
ure
English
Remedy
Inform the after-sales service
Press the "Reset" button
The oven solves the problem on
its own
Inform the after-sales service
Inform the after-sales service
Inform the after-sales service
Check the pipe position and the
level of cleaner in the tank; top
up if necessary and restart the
washing cycle.
If it is not possible to complete
the cleaning operation, perform
an emergency rinse or rinse the
cooking chamber by hand
Check the pipe position and the
level of sanitizing cleaner in the
tank; top up if necessary and re-
start the washing cycle
If it is not possible to complete
the cleaning operation, perform
an emergency rinse or rinse the
cooking chamber by hand
Press the reset button and rinse
the cooking chamber thorough-
ly by hand.
Operate the oven in convection
mode to dry the cooking cham-
ber.
Check that no residues of clean-
ing products have been left in-
side the cooking chamber.
Rinse the cooking chamber by
hand.
- 50 -
Notes
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle.
If the problem persists, call
the after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
If the problem persists, call
the after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
Use and installation manual