Recommendations For Use; Use And Operation - Angelo Po FX 82 G2T Manuel D'utilisation Et D'installation

SAFETY WARNINGS FOR ELECTRICAL EQUIPMENT
– The electrical equipment has been designed and constructed in accordance with the
relevant regulations. These regulations consider operating conditions in relation to the
surrounding environment.
– The list specifies the conditions required for the correct operation of the electrical
equipment.
- The room temperature must be between 5°C and 40°C.
- Relative humidity must be between 50% (measured at 40°C) and 90% (measured
at 20°C).
- The place of installation must not be a source of electromagnetic interference and
radiation (X-rays, lasers, etc.).
- The room must not have areas with concentrations of gas or powders which are
potentially explosive and/or represent a fire hazard.
- The products and materials used during production and maintenance must not
contain contaminants or corrosives (acids, chemicals, salts, etc.) and must not be
able to penetrate and/or come into contact with the electrical components.
- During transport and storage, the ambient temperature must be between -25°C
and 55°C. However, the electrical equipment may be exposed to a temperature of
up to 70°C, provided the exposure time does not exceed 24 hours.
If it is not possible to comply with one or more of the conditions listed, essential for
correct operation of the electrical equipment, agreement must be reached in the con-
tract concerning the additional features required to create the most suitable conditions
(e.g. special electrical components, air-conditioning equipment, etc.).

RECOMMENDATIONS FOR USE

Important
– The rate of accidents deriving from the use of appliances depends on many
factors which cannot always be predicted and controlled. Some accidents may
be caused by unpredictable environmental factors, while others are caused
above all by users' behaviour. As well as being authorised and adequately in-
structed, if necessary, when they first use the appliance, users should also try
out a few "dummy runs" on procedures in order to get to know the main controls
and functions.
– Use only as intended by the manufacturer and do not tamper with any devices
to obtain operations other than those intended.
– Before use, check that the safety devices are properly installed and in good
working order.
– As well as undertaking to comply with these requirements, users must apply
all safety regulations and read the description of the controls and the start-up
instructions carefully.
English

USE AND OPERATION

- 7 -
4
Use and installation manual
IT
GB
DE
FR
ES