Gas Connection; Water Connection - Angelo Po FX 82 G2T Manuel D'utilisation Et D'installation

GAS CONNECTION

Caution - warning
Make the connection in compliance with the relevant
legal requirements, using appropriate and recom-
mended materials.
To make the connection, connect the mains line to the ap-
pliance's connection pipe, fitting a shut-off tap (A), to allow
the gas supply to be cut off when necessary.
Important
The tap (A), not supplied with the appliance, must be
installed in an easily accessible position and its status
(on or off) must be obvious at a glance.

WATER CONNECTION

Caution - warning
Make the connection in compliance with the relevant legal requirements, using
appropriate and recommended materials.
Water supply connection
Connect the mains line to the appliance's connection
pipe, fitting a shut-off tap (B) to allow the water supply
to be cut off when necessary.
Important
The tap (B), not supplied with the appliance, must
be installed in an easily accessible position and
its status (on or off) must be obvious at a glance.
Caution - warning
The appliance must be supplied with drinking wa-
ter having the characteristics shown in the table.
If these characteristics are not complied with the
appliance might suffer damage; a water treat-
ment device should therefore be installed.
Description
Pressure
Water flow rate (l/h)
pH
Conductivity
Hardness
English
A
B
Value
200÷400 kPa (2÷ 4 bar) (*)
17,5 l/h (FX 82) (*)
17,5 l/h (FX 122) (*)
7÷7.5
< 200µS/cm
9÷13°f (5÷7°d, 6.3÷8.8°e, 90÷125 ppm)
- 25 -
IDM-39619300600.tif
IDM-39617701300.tif
Use and installation manual
IT
GB
DE
FR
ES