Angelo Po FX 82 G2T Manuel D'utilisation Et D'installation page 56

Alarm Fault
No water in chamber, or water
H2O
pressure too low
No water at drain, or water pres-
H2O.
sure too low
No mains gas, gas pressure too
low or flame detection failure
GAS
Oven door opening or closure
OPE
request
Indicates that cleaning is re-
CLE
quired
The cooking chamber probe
E01 has failed or is not properly con-
nected
The product core probe is not
E02
inserted in the food or has failed
IT
The steam discharge probe has
GB
E03
failed
DE
The motor-operated valve is not
FR
E04
positioned correctly
ES
E05 Safety thermostat failure
E06 Overload cutouts tripped
English
Remedy
Check that mains water is
present or adjust the pressure
(see page 30); if the problem
persists inform the after-sales
service
Check that mains water is
present or adjust the pressure
(see page 30); if the problem
persists inform the after-sales
service
Press reset button (the button
may have to be pressed several
times); if the problem persists
inform the after-sales service
Open or close the oven door
Inform the after-sales service if
this message continues to be
displayed
Clean
Inform the after-sales service
Check the position of the prod-
uct core probe or inform the af-
ter-sales service if it is faulty
Inform the after-sales service
Switch on the oven again and if
the problem persists inform the
after-sales service
Inform the after-sales service
Inform the after-sales service
- 20 -
Notes
Convection cooking cycles can
still be carried out
Convection and steam cooking
cycles can still be carried out
Stop cooking if this message is
repeated more than once
The cooking cycle does not start
until the door has been opened
or closed as required
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Cooking cycles with product
core probe cannot be carried
out
Convection and steam cooking
cycles can still be carried out
Convection and steam cooking
cycles can still be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
Use and installation manual