Angelo Po FX 82 G2T Manuel D'utilisation Et D'installation page 57

Alarm Fault
The optional vacuum probe has
E08 failed or is not properly connect-
ed
Electrical component compart-
E10
ment has overheated
E11
Electronic circuit board diag-
E13
nostics tripped
E14
E20 Setup error
The washing cycle has been in-
E23 terrupted during the final saniti-
zation stage
Automatic cleaning system fail-
E26
ure
E28 Valve has failed to close/open. Press the "Reset" button
English
Remedy
Press the "Reset" button
The oven solves the problem on
its own
Inform the after-sales service
Inform the after-sales service
Press the reset button and rinse
the cooking chamber thorough-
ly by hand.
Operate the oven in convection
mode to dry the cooking cham-
ber.
Check that no residues of clean-
ing products have been left in-
side the cooking chamber.
Rinse the cooking chamber by
hand.
- 21 -
Notes
Disconnect and reconnect the
vacuum probe before starting
the cooking cycle.
If the problem persists, call the
after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
The oven's functions are disa-
bled so no cooking cycles can
be carried out
If the problem persists, call the
after-sales service
If the problem persists, call the
after-sales service
The oven's functions are ena-
bled so cooking cycles can be
carried out
If the problem persists, call the
after-sales service
Use and installation manual
IT
GB
DE
FR
ES