Fastening The Rack And Pinion - SOMFY Slidymoove 300 Manuel D'installation Et D'utilisation

Installation
1

Fastening the rack and pinion

• The rack and pinion must be
fastened to the gate brace.
• Use screws suitable to the material
of your gate (see page 8).
• Never lubricate the motor rack or
pinion.
1
Rack fastening mark
• Open the gate completely.
• Position the pencil in the notches provided for
this purpose then slide the gate to mark the
anchoring point.
If required to anchor the rack, you can raise the motor by a maximum of 30 mm.
• Remove the motor and the mounting plate from the pins.
• Insert a nut and washer on each pin and position at the desired height (max. 30 mm from the ground).
• Replace the plate and motor on the pins.
• Check that the plate and motor are level.
10 10
EN - SLIDYMOOVE 300 installation and operating guide - SOMFY
• Fastening the rack at the top
of the oblong holes ensures
the 2 mm clearance necessary
between the rack and pinion.
• If the fastening points are too
close to the edge of the brace:
fasten the rack at the centre of
the oblong holes.
2
• Position the rack by aligning the top of the
oblongs holes with the mark.
• Fasten the first element of the rack at the top of
the oblong holes, beginning at the le -hand side
of the gate.
• Install and fasten the other items in the same
way, interlocking them with the others.