Electrical Connection Of The Motor - SOMFY Slidymoove 300 Manuel D'installation Et D'utilisation

Installation
1

1.8 Electrical connection of the motor

• For your safety, these operations must be
carried out with the power supply switched off.
• Use a 3 x 1.5 mm² cable or 3 x 2.5 mm² for
outdoor use (type H07RN-F minimum).
1. Strip the wire over a distance of
150 mm.
2. Overlap the live and neutral wires
at 100 mm.
3.
Strip the 3 wires over a distance of
8 mm.
4. Crimp the terminal provided
the earth wire (yellow and green).
5. Connect the earth wire supplied
to the top right of the control
electronics.
6. Connect the wires as shown in the
table:
Wire colour
Blue
Brown / black / red
Yellow and green
14
EN - SLIDYMOOVE 300 installation and operating guide - SOMFY
on
Type Terminal
Neutral 17
Live 16
Earth
• The cable clamp supplied must be used.
For all low-voltage cables, ensure that
they can withstand traction of 100 N.
Check that the conductors have not moved
when this traction has been applied.
100 mm
8 mm
150 mm
Comments
Screw the earth wire lug of the
electronics, the earth wire lug of the
power supply crimped in step 4 and the
star washer using the earthing screw
.
Neutral
Live