Commissioning And Standard Use; Switching The Installation On; Programming A 2- Or 4-Button Remote Control - SOMFY SLIDYMOOVE Manuel

2 COMMISSIONING AND STANDARD USE

Commissioning and standard use
2

2.1 Switching the installation on

1. The indicator flashes (twice).
The motor is switched on and awaiting
auto-programming.

2.2 Programming a 2- or 4-button remote control

1
• Position the remote control to
be programmed on the control
electronics target.
5 5
EN- Replacing the SLIDYMOOVE electronic unit - SOMFY
2. If the indicator light
the number of flashes is not as expected: see
diagnostic (in the installation and operating
guide of the motor).
2
• Briefly press the button on the remote control to be
programmed. The "RADIO" indicator light will come on
then go out when you release the button on the remote
control.
Complete opening is programmed on this button.
does not come on or
<0,5s