Installation 1; Unlock The Motor; Case Of Standard Installation; Fastening The Motor To The Ground - SOMFY Slidymoove 300 Manuel D'installation Et D'utilisation

1.1 Unlock the motor

1.2 Case of standard installation

Fastening the motor
to the ground
The metal plate supplied must be installed under the motor. The plate must be in direct contact with the
motor to ensure it is sealed and protected against large debris, insects, etc.
1
30 mm
• Place the metal plate
30 mm from the gate
and parallel to it.
• Mark the 4 anchoring
points for the metal
plate on the ground.
Once installation is complete, there will be 4 nuts and 4 washers unused.
2
• Remove the metal
plate.
• Drill the 4 holes in
the concrete using
a concrete drill bit,
diameter 12, to a
depth corresponding
to the plugs.
EN - SLIDYMOOVE 300 installation and operating guide - SOMFY

INSTALLATION 1

• Remove the motor cover.
• Press on the lever (on the right, grooved
section).
• Pull the lever.
The pinion is freed.
The motor is unlocked.
12 17 T25
3
• Insert the 4 plugs
into the concrete
and screw the 4
pins using the torx
screwdriver.
• Position the metal
plate level.
4
• Remove the motor
cover.
• Position the motor on
the pins, feeding the
cables through the
locations provided for
this purpose.
• Tighten the washers
and nuts.
9