Corghi EM 9580 Manuel D'utilisation page 63

Masquer les pouces Voir aussi pour EM 9580:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Wheel data entry for wheel
balancers with an ultrasonic
sensor (if installed)
To enter the distance, diameter and width values
automatically, proceed as follows:
- Bring the automatic measuring arm into contact
with the inner side of the rim (fig.14). Take great
care to position the arm correctly so as to ensure
accurate data reading.
- Keep the arms in contact with the rim until the
machine has acquired the values. Geometric
data (distance, diameter and width) are dis-
played. The following screen appears during
this phase:
- if only one measurement is taken, the machine
interprets the presence of a rim with balanc-
ing using a clip weight (Dynamic Balancing
Programme)
- when the automatic internal measurement arm
returns to the rest position, the following icons
are automatically displayed on the screen:
EM 9580 - Operator's manual
-
: pressing the Kis knob or the ENTER
button enables alternatively the type of tyre,
that is P TYRE
for medium sized wheels (wheels with a tyre
shoulder that does not protrude much from the
rim) or LT TYRE
for large sized wheels (such as off-road, trucks
or wheels with a tyre shoulder that protrudes
considerably from the rim);
-
: pressing the Kis knob enables the
manual entry of the width;
- Pressing the
ed phase returns to the working environment,
maintaining the previous width.
- in this phase, it is possible to perform a new
acquisition of the rim planes.
- lowering the guard confirms the selection that
was made (manual width entry or wheel type
selection) and the width scanning and spin are
performed.
Note:
- automatic width acquisition is re-enabled only
with a new acquisition of the automatic internal
measuring arm;
- if the wheel guard is closed or in the case of
(Passenger Tyre)
(Light Truck Tyre)
button during the indicat-
63
UK

Publicité

Table des Matières
loading

Table des Matières