Installation - Tecno-gaz CLIP Manuel De L'utilisateur

INSTALLATION (FOUNDATION)
Because of the characteristics of the device is important to follow certain
precautions:
The device should not be used in potentially explosive atmospheres.
Remove packaging, and check the status of the unit.
If any signs of damage to vehicles, alert the manufacturer.
Packaging must be preserved throughout the warranty period.
The manufacturer does not accept returns without original packaging.
It must be transported following the rules for the transportation of fragile goods.
The original packaging should be kept for the duration of the guarantee period, since
only in this container it is possible to avoid damages during transport.
Place the unit on a horizontal surface, away from heat sources.
Connection and putting into service:
The electrical connection must be made in accordance with current technical
regulations.
Make sure the measured mains voltage value corresponds to that written on the
machine's identification plate.
Make sure the electrical systems are efficiently earthed.
PUT THE POWER SUPPLIER NEAR A SOCKET, IN A DRY PLACE WHICH IS WELL
PROTECTED AGAINST HITS AND FLOWING LIQUIDS.
The power supplier can be placed on a flat surface (e.g. the floor) or mounted on the
wall.
To fix it on the wall make 2 holes and fix with 2 dowels (interaxis 70 mm) (Figure 2)
11
ENGLISH