Troubleshooting And Assistance; Replacement Parts List; Service Instructions - Meister AS18A Traduction Du Manuel D'utilisation Original

15 – Troubleshooting and assistance
Faults
No functionality.
On/Off switch
cannot be pressed.
Machine does not start up.
Drill does not cut/hardly cuts
into the material to be drilled.
In the event of any other faults and errors, consult the customer service
department detailed in the guarantee documentation.
16 – Replacement parts list
The following parts may be pur­
chased by ordering from the cus­
tomer service department. They are
also available from your specialist
dealer.
Battery pack: MAS18WAP
Art.­Nr.: 5401440
17 – Service instructions
• Store the machine, operating
instructions and where necessary
the accessories in the original
packaging. In this way you will
always have all the information
and parts ready to hand.
5400440-Akku-Bohrs_man1.indd 73
Potential causes and remedies
– Rechargeable battery charged?
– Rotation direction switch set to cen­
tre position?
(Machine cannot be switched on).
­ The rotation direction switch
is in the centre position
– It is possible that the carbon
brushes are worn.
Consult a specialist workshop.
– Hammer drilling required?
– Correct drill bit selected?
– Is the machine accidentally set to
left rotation?
• Meister devices are to a large
extent maintenancefree, a damp
cloth being sufficient to clean the
casing. Do not drop electrical
machines in water. Please note
additional hints given in the oper­
ating instructions.
• Meister devices are subject to
stringent quality control. If howev­
er a functional fault shoult occur,
send the device to our servicing
address. The repairs will be car­
ried out in a short time.
• A brief description of the defect
speeds up the faulttracing and
repair time. If within the guarantee
period, please enclose the guar­
antee document and the proof of
purchase.
73
17.06.19 10:59