Installation And Setting - Meister SB1010M Mode D'emploi

containing asbestos must only be pro-
cessed by specialists.
• Ensure that the workspace is well
ventilated.
• The use of a respirator mask with a
grade P2 filter is recommended.
Observe the applicable national regu-
lations relating to the materials to be
processed.
• Avoid the build-up of dust in the
workplace. Dust can easily ignite.
Use a suitable vacuum cleaner after
work to collect the dust / dirt.
Safety symbols
The symbols on the housing have the
following meanings:
Do not dispose of with
domestic waste!
Important! Observe operat­
ing instructions!
Important! Wear goggles.
Important! Wear ear
defenders.
„Tested Safety" voluntary
quality mark
CE Mark (conformity to
European safety standards)
Housing is double insulated
Right/Left direction
42
5402270-Schlagbohrmaschine_man.indd 42 5402270-Schlagbohrmaschine_man.indd 42
Impact rate
Maximum drill diameter
BJ Year of construction
SN: Serial number
SN: XXXXX The first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
Mounting the additional handle
The additional handle (6) can be mounted
on the right or the left of the chuck, as
required. Release the handle piece of the
additional handle by turning to the left
until it can be pushed over the chuck (8)
and onto the tensioning neck. The holder
cams on the underside of the tensioning
neck must fit into the holder grooves of
the tensioning ring. This allows you to
select a comfortable working position
and, at the same time, secures the addi-
tional handle from vibration-related slid-
ing. Tighten the handle piece, by turning
to the right until the additional handle is
fixed to the machine.
Mounting the depth stop
Loosen the additional handle (6) so that
the hexagonal screw exposes the open-
ing for the depth stop. Slide the depth
stop (7) into the opening and tighten the
handle.
Setting the depth stop
• Fit the drill and lock into place.
• Loosen the additional handle.
13.08.20 06:45 13.08.20 06:45