This cordless drill/screwdriver
Meister AS18A may only be charged
with the charger RSS1006324216
W2EBDC. Any use of any other
charger or use of the charger
RSS1006324216W2EBDC con
nected to a power supply other than
the one listed may lead to personal
injury and damages.
We reserve the right to make techni
cal changes.
is a registered trade mark of
Conmetall Meister GmbH ·
Wup pertal/Germany
Noise emission/vibration
Noise emission
Sound power level
L
: 67.8 dB(A)
WA
Uncertainty K
WA
Sound pressure level
L
: 78.8 dB(A)
pA
Uncertainty K
: 3.0 dB(A)
pA
Hand/arm vibrations
Drilling into metal:
a
: 1.756 m/s
2
h
Uncertainty K: 1.5 m/s
Noise/vibration information
Measured values determined
in accordance with EN 62841.
The specified vibration emission
value was measured in accordance
5400440-Akku-Bohrs_man1.indd 67
: 3.0 dB(A)
2
.
with a normed test procedure and
can be used in order to compare
one electrical tool with another.
The specified vibration emission
value can also be used for an intro
ductory evaluation of the influence.
CAUTION! The vibration emis
sion value may fluctuate from
the specified value during use of
the power tool. These fluctuations
will depend on the way in which
the power tool is used.
Try to keep the vibration loads
as low as possible. Examples of
measures that may be taken to
reduce the vibration load include
wearing gloves when using the
tool and limiting the length of the
working period. All parts of the
operating cycle must be taken
into account for this purpose
(for example, by also including
times in which the power tool is
switched off and times in which
it is switched on, but is running
without load).
CAUTION! A certain amount
of noise is unavoidable when
using this device. Ensure you
carry out noiseintensive work
during permitted times. Maintain
the quiet periods and limit your
work to the absolute minimum.
CAUTION! The effects of
noise may cause damage to
the hearing. Only ever work with
suitable ear defenders. Anybody
else in the vicinity should thus
also wear ear defenders.
67
17.06.19 10:59