Installation And Setting; Operation; Mode Of Operation - Meister MPH1400-1 Traduction Du Manuel D'utilisation Original

5452820-Bohrhammer_man 12.02.18 12:19 Seite 52
7 – Installation and setting
Inserting a tool
CAUTION! Unplug from
the power source.
The tool holder is suitable for
tools that use the SDS-plus
system
Point the tool holder (5) upwards.
Insert a lightly oiled tool shaft and
turn to the locking point by applying
a slight pressure. The holding sleeve
(5a) does not need to be pushed
down to do this.
Removing the tool
Push the holder sleeve (5a) back
and remove the tool.
Adjusting the additional handle (3)
(Figure 4)
Loosen the additional handle by
turning to the left, via the tool
holder to the position shown in
Figure 1 and set a comfortable side
working position by sliding about
the drilling axis. Turn the additional
handle to the right to secure.
Mounting and setting the depth
stop (6) (Figure 1)
Loosen the wing screw (7) on the
additional handle (3) until the depth
stop (6) can be moved into the
clamping opening (4). Pull the depth
stop to the tip of the inserted drill
52
bit. Push the tool with the drill bit
and the depth stop up against a flat
surface and slide the depth stop
back to the required drilling depth
(Figure 4). Fix the setting by
tightening the winged screw (7). The
front of the depth stop will touch
the relevant surface when the set
drilling depth is reached. You may
wish to make a test hole.
8 – Operation
Switching on and off
CAUTION! The voltage of
the power supply must
correspond to the
specifications on the type plate
of the machine.
• Switching on: Press the On/Off
switch (1).
• Switching off: Release the On/Off
switch (1).
Vibration damper (10)
The power tool has a mechanism for
reducing the vibrations at the
handle (2) (Figure 1).
9 – Mode of operation
Meanings of the symbols drill,
hammer drill, chase
Drilling without hammer
action (Figures 3A/8) into
wood and metal. For this
mode, a conventional
toothed chuck with adapter