Operation - Meister AS18A Traduction Du Manuel D'utilisation Original

Battery pack charge monitoring
(Figure 4)
To monitor the charge state, the
battery capacity status display (4)
lights up during operation.
The charge state is shown as fol­
lows:
• Green/Yellow/Red:
The rechargeable battery is fully
charged.
• Yellow/Red:
The rechargeable battery is par­
tially discharged.
• Red:
The rechargeable battery must be
charged.
9 – Operation
Torque pre­selection
The cordless drill/screwdriver has
a torque setting function with 25+1
levels which helps to avoid dam­
age to the screw or drill head. By
rotating the torque setting (2) on
your cordless drill/screwdriver, you
can select the required level, from 1
(easy screw driver action) through to
maximum (heavy­duty screwdriver/
drilling action). Always select the
most appropriate torque for the job
in hand.
Do not use the drill setting for
screwdriver work.
Tensioning a tool
Traditional screwdriver bits, bit
holder and drills up to a diameter of
10 mm can be used in the chuck (1).
Only use a tool that can be clamped
securely in the chuck and which is
5400440-Akku-Bohrs_man1.indd 69
designed for use with this machine.
See „Technical data".
The machine has a quick­action
chuck (1). This allows you to
change accessories by hand quickly
and without a chuck key.
• Open the claws of the quick­ac­
tion chuck. To do this, rotate the
quick­action chuck anti­clock­
wise. Open the quick­action
chuck far enough to be able to
insert the tool.
• Insert the tool in the quick­action
chuck.
• Rotate the quick­action chuck
clockwise and tighten securely.
CAUTION! Accidentally
switching the machine on is
an injury risk. Set the switch for
the rotation direction to the mid­
dle setting when the machine is at
a standstill in order to activate the
lock for the On/Off switch.
CAUTION! Risk of cuts.
• Wear gloves to insert a drill into
the quick­action chuck.
• Tighten the quick­action chuck
to clamp the tool in place.
The chuck of right/left rotat­
ing machines is always fixed
with a left­threaded screw. This
must be loosened from the front
through the chuck (1) before
changing it. Left­threaded screws
can only be loosened by turning
to the right.
69
17.06.19 10:59