Installation And Setting - Meister TBS350-2M Traduction Du Manuel D'utilisation Original

5452530-Tischbohrm_man 09.03.18 07:23 Seite 45
Warning labels
When working with the table
drill wear goggles.
Wear ear defenders when
using the table drill.
Within the EU, this symbol
indicates that this product may
not be disposed of with the
ordinary household waste. Old devices
contain valuable recyclable materials which
should be recycled in order to ensure that
they do not affect the environment or the
health of humans as a result of
uncontrolled waste disposal. Please
dispose of old devices via a suitable
collection system or return it to the place it
was purchased for disposal. They will then
send the device for recycling.
Read these operating
instructions through
thoroughly before you start
to use the table drill.
After 30 minutes of constant
operation, take a break to
allow the unit to cool down
Maximum material thickness
Maximum drill diameter
Belt/pulley combination for
500 min - 1
-
890 min 1 safe maintenance of the
1400 min -
1
appropriate revolutions
1900 min - 1
-
2 500 min 1
Never reach into the running
belt drive! Do not attempt to
stop the belt pulley with your
hands!
"GS" voluntary quality mark
CE marked (conforms to
European safety standards)
Wear a hair net if you have
long hair
Do not wear gloves when
working with the device
Pull out the plug when
servicing or setting up the
machine
Never remove chips by hand
– risk of injury
Suitable materials
Cast iron
Steel
Aluminium
Wood
Plastics
7 – Installation and setting
Installation
Arrange the packing groups in the order
A – G.
• Mount column (E) on base plate (C)
with screws (D).
45