Changing The Protection Grid On The Bottom - Vorwerk Thermomix TM5 Manuel D'utilisation

Changing The PROTeCTiOn gRiD

Changing the protection grid on the bottom

To install the protection grid on the bottom of the Thermomix™, disconnect
the Thermomix™ from the mains power supply. Remove the mixing bowl and
tilt the Thermomix™ as shown 1 . Take the protection grid for the bottom 2 .
It has an oval bump that must face the bottom of the Thermomix™ 3 .
Lay the protection grid under the upper ridges, then press down until you hear
that the grid has locked in place 4 .
To remove the protection grid, disconnect the Thermomix™ from the mains
power supply first. Remove the mixing bowl and tilt the Thermomix™ in
the same way as when you inserted the grid. There is a tab at the left of the
protection grid. Pull on this to remove the protection grid.
1
4
50 Changing the protection grid
2 3