Actuator Installation - Erreka FENIX Manuel De L'utilisateur

INSTALLATION
• The installation must be able to support the
power consumed by all the automatic
operation devices.
• The installation must be earthed.
• The electrical installation must comply with
low voltage regulations.
4

ACTUATOR INSTALLATION


Assembly positions and levels (sectional door)
1 Front support
2 Door anchoring
3 Overhead strips

Level A: the track (4) should remain 10 cm
above the highest point of the door (see detail
A ).

Level B: in accordance with the chosen track
(track ref. AFE01: 3m; track ref. AFE02: 4m).
Fig. 4 Assembly positions and levels
54
Installation Manual
• The installation elements must be properly
secured and in a good state of conservation.
• The current connection point must be high
enough to be out of the reach of children.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic operation device.
4 Actuator track
5 Door tracks
6 Door

Level C: height of the unlocking cable (7):
approximately 1.8 m over the ground (lengthen
or shorten as appropriate).
O
The track (4) must be horizontal.
7 Unlocking cable
8 Carriage
9 Actuator