Setting The Default Configuration Of The Machine; Understanding The "Settings" Sub-Menu - Hürner HWW-1000 Manuel Utilisateur

ability data can also be entered after pressing the  arrow key in the
standard screen.
At this point, it is imperative to set the nominal speed, with
the potentiometer, and the nominal temperature, which
shows on the display, with the arrow keys ò and ñ, for the
Info
next welding. The set points are saved to memory after 10 sec
with no further changes. With enabled buzzer (see Sect. 4.2),
the buzzer indicates this by an audible signal.
4.2

Setting the Default Configuration of the Machine

The Configuration Menu is accessible by pressing the MENU key when
Display 2 is showing on the screen. Opening the menu requires the
input of an access code, which is disclosed to authorized personnel with
the operating company. The menu first shows a possible selection of
"Settings," "Recording," and "Sensor Parameters" (see Display 3).
At "Settings" the settings for the machine itself and its operation can
be defined. At "Recording" it is possible to enable or disable the trace-
ability data that should be recorded or not recorded for the welding
reports. Setting the sensor parameters is not needed as part of the
daily routines. This item is additionally protected by a further access
code that will be disclosed to authorized staff with the operating
company only. To select what you need, use the ñ and ò arrow keys.
To open the desired sub-menu, press the MENU key.
In all parts of the Configuration Menu, use the ñ and ò arrow keys
to select the desired set-up option. Use the ð arrow key to toggle
between "on" and "off" for that set-up option.
If a "M" is shown next to a set-up option, this indicates that a sub-
menu is accessible here by pressing the MENU key.
Press the START/SET key to confirm the set-up and save it to
memory.
4.3

Understanding the "Settings" Sub-menu

"Memory Control on" means that when the system memory is full of
reports, the unit will be blocked until the reports are printed or
downloaded, "off," that it works but that the oldest report will
be overwritten.
"Language – M – " means that by pressing the MENU key, the user
can access a sub-menu for selecting the display language (see
Sect. 4.3.1).
"Date/Time – M – " means that by pressing the MENU key, the user
can access a sub-menu for setting the clock (see Sect. 4.3.2).
"Buzzer on" means that the audible status signal of the welder works,
"off" that it is muted.
"Buzzer Volume – M – " means that by pressing the MENU key, the
user can access a sub-menu for setting the volume of the status
buzzer (see Sect. 4.3.3).
"Temperature Unit – M – " means that by pressing the MENU key, the
user can access a sub-menu for selecting centigrade or Fahrenheit
as the unit for the temperature.
"Length Unit – M – " means that by pressing the MENU key, the user
can access a sub-menu for selecting millimeters or inches as the
unit for length.
"Inventory Number – M – " means that by pressing the MENU key,
the user can access a sub-menu that allows entering the identi-
fier under which the welder is filed in the user's inventory (see
10
EN
HÜRNER HWW–1000 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
*** SET-UP MENU ***
>Settings
Recording
Sensor Para.
*** SET-UP MENU ***
>Memory Control
Language
Date/Time
*** Inventory No.***
xxxxxxxxxxxxxxx
[RESET]
Version September 2018
-M-
-M-
-M-
Display 3
on
-M-
-M-
Display 4
[SET]
Display 5