Recording The Geo-Data Of The Planned Joint; Aborted Welding Process - Hürner CNC ECO 355 2.0 Manuel Utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Report data (sample)
Material /
Welding Mode
Diameter
Wall Thickness
SDR Value
Angle
4.4

Recording the Geo-data of the Planned Joint

Provided that geo-data recording is enabled in the configu-
ration menu (see Sect. 4.1), the geographic coordinates can
be recorded, if the GPS module is on, as soon as Display 31
shows on the screen.
Wait at least 1 minute from switching the GPS mod-
ule on to the actual recording of the geo-data, or
the GPS module will throw a not-ready error.
Important
During the first minute after switching the GPS module on
the following messages may appear on the screen: "No sig-
nal," "GPS module failed," "GPS Error, Restarting," and "GPS
Module not Ready." These are no errors during the starting
minute of initialization right after switching on. If they ap-
pear after this time, they have to be considered actual error
messages. In this case, the restart after a GPS (signal process-
ing) error will be performed by the module itself, without
any user action. The Not Ready message disappears auto-
matically, too, as soon as the module is ready for recording.
The geo-data are recorded after you selected "Yes" in Dis-
play 31 using the ñ and ò arrow keys and confirmed this se-
lection by pressing the START/SET key. A message confirms
that the data have been recorded. The recorded data then
show on the screen (see Display 32). A second screen is used
to display additional information on the precision at the
time of recording. To switch back and forth between both
geo-data screens, press the ð key.
If it is likely that no satisfactorily precise position will be re-
corded because of relatively poor signal strength, a warning
message tells you, after you pressed the START/SET key in
Display 31, "Poor GPS signal; record data?". When this mes-
sage is showing, you can still start recording the position by
pressing the START/SET key or go on without recording by
pressing the STOP/RESET key.
4.5

Aborted Welding Process

All parameters relevant to the welding are constantly moni-
tored while the process is running. If one or more of them
are out of tolerance and the machine cannot adjust them
within a specified delay, the welding process is aborted.
Version October 2022
PE 100
[mm] 1200
[mm] 109.1
SDR 11.0
[°] 0
HÜRNER CNC ECO 355 2.0 User's Manual
-C-HC-
Record Geo-Data
>Yes
No
Current Position
050·38,4873'N
008·59,4141'E
Sat:7
WELDING ABORTED
Error Build-up Pres.
229°C
Display 31
Display 32
ACT. 1.5bar
Display 33
27
EN