Setting The Default Configuration Of The Machine - Hürner CNC ECO 200 Manuel Utilisateur

If the machine configuration requires the input of traceability data
for the joint that is going to be welded (commission number, welder
identification code, etc.), then input screens for these data are shown
before Display 4 appears.
The joint number, or weld number, is based on the job/commission
number. This means that it increments by 1 for every welding opera-
tion performed in the scope of the current commission (identified
previously by entering the appropriate job number). In the example in
Display 4, the next welding operation will be saved to welding report
number 72 while the joint itself is joint number 2 of the current job/
commission. For the joint number to be displayed, this option has to
be enabled in the Configuration Menu.
The first joint of a commission for which no joint has been
saved to memory so far, always receives no. 1. If the memory
already holds joints for a commission, the machine finds the
highest number of the joints existing for that commission
Info
and uses this number plus 1. The user is shown the number
thus found on the screen and can apply or change it. If the
user changes the joint number, it is his responsibility to make
sure that no number is assigned twice in one commission. If
a joint number appears twice in a commission, this will not
affect the welding process and the logging of its data in
any way. However, in that commission two joints will not be
distinguished by a unique number.
If user inputs leave some joint numbers unused (for instance,
for a given commission no. 1, 2, 3, 5, 6, 9), the gaps do not
get filled, and the automatically found number proposed for
the next welding operation will still be the highest existing
number plus 1 (that is, 10 in this example).
The joint number can also be entered after simultaneously pressing
the cursor keys  and ð when Display 4 is showing on the screen.
After it was turned on, the machine generally is in its "open"
position (see above). It is possible to bring the movable car-
riage to any desired position by pressing and holding down
the INCREASE PRESSURE key. The carriage can then be sent
Info
back to the "open" position by pressing the OPEN key.
Depending on the software version installed in your machine,
some screens may be slightly different on your display than
the reproductions in this manual.
Info
4.2 Setting the Default Configuration of the Machine
The Configuration Menu is accessible by pressing the MENU key when
Display 4 is showing on the screen.
When the operator presses the MENU key, the screen asks to enter a
selection code (see Display 5). This is an access code that authorizes
the operator to select and change the default configuration that de-
termines how the machine behaves at every new welding operation.
The selection code can be entered by typing it on the keypad or by
reading it from a transponder card.
After entering an incorrect code three times, the machine
returns to its "open" position (see Sect. 4.1 and Display 4). If
the entered menu selections code is correct, the Configura-
Important
tion Menu shows on the screen, as in Display 6.
12
EN
HÜRNER CNC ECO 200 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Enter Select Code
++++++
CODE: 415311
Settings
>Report Generat. -M-
Sensor Params
Machine Data
Version February 2018
Display 5
-M-
-M-
-M-
Display 6