Maintenance; Scheduled Maintenance Table - Nilfisk ECOFLEX Adfinity 17ST Instructions D'utilisation

ENGLISH

MAINTENANCE

The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance.
The following table provides the scheduled maintenance. The intervals shown may vary according to particular working conditions,
which are to be defi ned by the person in charge of the maintenance.
WARNING!
The procedures must be carried out with the machine off and the battery disconnected.
Moreover, read carefully the instructions in the Safety chapter before performing any maintenance procedure.
All scheduled or extraordinary maintenance procedures must be performed by qualifi ed personnel, or by an authorized Service
Center.
This Manual describes only the easiest and most common maintenance procedures.
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be consulted
at any Service Center.

SCHEDULED MAINTENANCE TABLE

Procedure
Battery charging
Squeegee cleaning
Brush/pad cleaning
Tank and vacuum grid with fl oat cleaning, and cover gasket check
EcoFlex™ system cleaning and draining
Squeegee blade check and replacement
Solution/clean water fi lter cleaning
Vacuum system motor fi lter cleaning
WET battery fl uid level check
Screw and nut tightening check
Brush/pad-holder motor carbon brush check or replacement
Vacuum system motor carbon brush check or replacement
Drive system motor carbon brush check or replacement (only for
Adfi nity™ X20R)
Vibration-damping replacement (only for Adfi nity™ X20R)
(1) And after the fi rst 8 working hours.
(2) This maintenance procedure must be performed by an authorized Advance Service Center.
18
INSTRUCTION FOR USE
9096912000(4)2010-11
Daily, after ma-
Weekly
chine use
Adfi nity™ 17ST - 20ST - X20R
Every six
Yearly
months
(1)
(2)
(2)
(2)
(2)