Symbols Used; Intended Use - Truma MonoControl CS Mode D'emploi

MonoControl CS gas tank
Table of Contents

Symbols used ...................................................................... 11

Intended use ........................................................................ 11

Safety instructions .......................................................... 12
Operating instructions
Start-up .............................................................................. 13
Checking for leaks in the high-pressure section ....... 13
Checking for leaks in the low pressure section ......... 13
Maintenance ..................................................................... 14
Accessories ....................................................................... 14
Technical data ................................................................. 14
Installation instructions
Safety instructions .......................................................... 15
Installation options .......................................................... 16
Installation dimensions ................................................... 16
MonoControl CS gas tank installation and
connection ........................................................................ 17
Manufacturer's Warranty
(European Union) .............................................................. 18
Symbols used
The unit may only be installed and repaired by an
expert.
Symbol indicates possible hazards.
Note containing information and tips.
Intended use
MonoControl CS is a safety gas pressure regulation system
for caravans and motor homes. The gas tank version is for
direct connection to the extraction valve with a male thread
W 21.8 x 1/14 LH (G.5). The gas pressure regulation system
ensures a uniform output pressure of 30 mbar with a permis-
sible admission pressure of 0.3 - 16 bar.
The integrated crash sensor interrupts the flow of gas in the
event of an accident with deceleration of 3.5 g ± 0.5 g * act-
ing directly upon the triggering element.
* With an average vehicle weight, this corresponds to a colli-
sion speed of approx. 15 - 20 km/h with a fixed obstruction.
The integrated overpressure safety device complies with the
requirements for a commercial safety device against excess-
ively high pressure increases (for example, in Germany ac-
cording to DGUV regulation 79 - previously BGV D 34).
11