Control panels CP (E) classic
Table of Contents
Symbols used ...................................................................... 14
Intended use ..................................................................... 14
Start-up .............................................................................. 16
Hot water mode .................................................................. 16
Switching off .................................................................... 17
Fault .................................................................................... 17
Electrical mode .................................................................... 18
Mixed mode ........................................................................ 18
Accessories ....................................................................... 18
Technical data ................................................................... 23
Maintenance ..................................................................... 23
Disposal ............................................................................. 23
Assembly ........................................................................... 24
Symbols used
The unit must only be installed and repaired by an
expert.
Note containing information and tips.
Please pay attention to the ESD regulations!
Electrostatic charge can destroy the electronics.
Ensure that potential compensation is present before touch-
ing the electronics.
Intended use
Control panel - CP classic
The room temperature and the water temperature can be set
at a Truma Combi (E) heating system using the control panel.
Power selector switch - CP E classic
It is possible to choose between gas, diesel and/or electrical
energy at a Truma Combi (E) heating system (with heating
elements for electrical mode) using the power selector switch.
The CP classic control panel is also required.
The control panels are intended for installation in caravans
and motor homes. Installation in boats is not permitted.
13