Entering Height Value (Height) - Seca 787 Mode D'emploi Et Garantie

108,2 cm

Entering height value (Height)

30 •
2. Release the head slide by pressing on the latch and moving the head slide
downward.
3. Fold up the measuring flap until it engages in a horizontal position.
4. Ask the patient to stand under the measuring flap:
5. Push the head slide on the lower telescopic element down until the
measuring flap is in contact with the patient's head.
6. Read off the measuring result below the head slide (read-off edge 1) (in
this case: 108.2 cm).
You have the following options for continuing:
7. Ask the patient to step off the weighing platform.
8. Fold down the measuring flap.
9. Push up the head slide until it engages in the latch.
.
If you are measuring in the range < 1.22 m, the height value can be entered
on the display unit and used for the following functions:
• Calculating BMI (➔ "Calculating and displaying body mass index (BMI)",
• Transmitting measured values to the
– Upright posture
– Head straight (Frankfort horizontal plane, parallel to measuring flap)
► Make a note of the measuring result
► Enter the measuring result on the display unit (➔ "Entering height
value (Height)", page 30)
page 32)
(➔ "Scanning ID(s) and transmitting data via WiFi (seca 797)", page 32)
software via WiFi
seca connect 103