Deleting Saved Values Automatically (Aclr); Permanently Saving The Additional Weight (Pt) - Seca 674 Mode D'emploi

tare
enter
Deleting saved values
automatically (AClr)
Permanently saving the
additional weight (Pt)
PT
Sto 1 (Weight)
Sto 2 (Weight)
Sto 3 (Weight)
Net Weight
70 •
5. To amend the setting or call up a different sub-
menu, press one of the arrow keys until the desired
setting (in this case: level "2") is displayed.
6. Confirm the setting with Enter (Enter).
You exit the menu automatically.
7. To make more settings, call up the menu again and
proceed as described.
NOTE
If no key is pressed for about 24 seconds, you
exit the menu automatically.
To prevent current measurement results remaining in
the memory of the device and leading to an incorrect
BMI calculation, you can set the scale so that measure-
ment results are automatically deleted after 5 minutes.
NOTE
This function is activated at the factory on some
models. You can deactivate the function if desired.
1. Select the item "AClr" from the menu.
2. Confirm your selection.
3. Select the desired setting:
– on
– off
4. Confirm your selection.
You exit the menu automatically.
This function is suitable for patients who are not mobile
and who will have to be weighed in a wheelchair, for
example. You can save the tare weight of the wheel-
chair independently of a weighing operation. You can
call up the tare weight of the wheelchair during the
weighing operation and have it deducted from the
measured result automatically.
The device has three memories for weights. You can
save various weights and call them up individually
depending on the initial situation, so that they are auto-
matically deducted from the measurement result.