Identifying The Product; Understanding The Machine; General Information; Contents Of Shipment, Specifications, And User Controls - Hürner HWT 400-M Manuel Utilisateur

persons who are needed and instructed may remain close to
the machine, and appropriate lifting tools have to be used.
2.9

Identifying the Product

Every product is identified by a name plate. It shows the model ("Typ"),
the serial number ("Geräte-Nr."), and the manufacturer. The first two
digits of the serial number represent the year of manufacture.
3

Understanding the Machine

3.1

General Information

This butt-welding machine for plastics can be used only indoors as a
workshop installation, for jointing straight pipe to straight pipe or
segmented bends, but also for making tees, Y branch-offs, and cross-
pieces (see also Sect. 3.4 and 5.1, 5.2 for more detailed information).
3.2 Contents of Shipment, Specifications, and User Controls
The explications below are meant to contribute to a clear under-
standing of the designations used in this manual for referring to the
machine parts.

3.2.1 Included Components

• Workshop butt-welding machine up to O.D. 400 mm, including
LH/RH master pipe clamp assemblies O.D. 90 - 400 mm
• Assembly with electrical heating element with anti-stick coating
and electrical facing tool
Optionally available
• Clamp assemblies for tees, crosspieces, and Y branch-offs
• Welding neck support
• Clamps for molded fittings and welding neck
• Additional cylinder

3.2.2 Component Overview

8
EN
HÜRNER HWT 400–M User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Workshop Welding System HWT 400–M
Geräte-Nr. 20904008
Netz 3 Ph + PE 400 V AC 50 Hz 9 kW-
Arbeitsbereich: 90 mm - 400 mm
Baujahr: 2020 Gewicht 557kg
HÜRNER Schweisstechnik GmbH
Nieder-Ohmener Str. 26
D - 32325 Mücke
+49 6401 9127 -0 Fax -39
Facing Tool
Reducer Inserted into
Master Clamping Assembly
Master Clamping Assembly
(steel clamping assembly shown; refer to
Sect.. 3.4 for more information)
Heating Element under Housing
Carriage for the Clamping Assembly
Facing Tool Support Bracket Set
on Rails for Transverse Facing
Tool/Heating Element Movement
Facing Tool Power Supply
(cord not shown)
Control Terminal
Mains Supply Cord 400 V
On/Off Switch
Maintenance Door
Version January 2020