Mounting Of Specimen Mover (Optional); Rotoforce-3/4; Pedemat/Pedemax-S - Struers RotoPol-31 Mode D'emploi

Mounting of
Specimen Mover (Optional)

RotoForce-3/4

Pedemat/Pedemax-S

16
RotoPol-31/-35
Instruction Manual
RotoPol-31/-35 can be equipped with a RotoForce-3 or a
RotoForce-4 specimen mover. To mount the specimen mover, see
the Instruction Manual of the specimen mover.
Older versions of the specimen movers: Pedemat (PEDRO) or
Pedemax-S (PEDSO) can be mounted on RotoPol-31/-35, operating
with automatic start and stop. In such a configuration, however, a
RotoCom unit cannot be connected.
Fastening screws.
Support hole.
Remove the cap covering the support hole placed on the top of
the RotoPol-31/-35 cabinet by lifting it with a knife.
Remove the two caps covering the fastening screws on the
left- hand side of the RotoPol-31/-35 cabinet by lifting them
with a knife.
Remove the black plastic ring from the supporting column of
Pedemat/Pedemax-S.
Lead the supporting column of the specimen mover down into
the support hole in RotoPol-31/-35. Turn the column until the
cross pin in the bottom of the column gets caught by the
guiding slots inside RotoPol-31/-35.
Tighten the two fastening screws on the left-hand side of the
RotoPol-31/-35 cabinet by means of the hexagon key included
in the packing case, and mount the two caps again.