Installing The Mounting Unit; Installing The Cover; Installing The Dust Protection Ring; Installing The Swivel Arm - Struers ProntoPress-20 Mode D'emploi

Installing the Mounting Unit

Fixation screw

Installing the Cover

Installing the
Dust Protection Ring

Installing the Swivel Arm

Mounting of the Top Closure

ProntoPress-20
Instruction Manual
Unscrew the fixation screw about 10 mm.
Place the mounting cylinder over the lower ram with the
fixation screw in the position shown.
Turn the mounting unit in a clockwise direction until it stops.
Tighten the fixation screw completely.
Mount the tube with the straight quick coupling on the lower
quick coupling of the mounting unit (pos.
connect. Make sure that the ring comes to stop in the extreme
end of the quick coupling.
Mount the tube with the elbow quick coupling on the upper
quick coupling of the mounting unit (pos.
Plug
connect. Make sure that the ring comes to stop in the extreme
end of the quick coupling.
Mount the plug in the socket. Tighten the coupling nut.
Introduce the barb in the front of the opening for the cover.
Introduce the barbs on both sides of the cover in the cabinet.
Press the sides of the cabinet gently.
Press the rear end of the cover in so that the catch engages.
Place the dust protection ring around the mounting cylinder. The
concave side should face upwards.
Insert the rod in the hole at the top of the cover for the mounting
unit.
Introduce the top closure in the hole at the top of the swivel arm.
Do not operate the machine whilst installing the mounting unit
Important
Mounting cylinder
Fixation screw
Upper quick coupling for
cooling water
Lower quick coupling for
cooling water
Plug
) and push to
) and push to
7