Corghi EM 7240 Manuel D'utilisation page 90

Proceed as follows to balance motorcycle wheels dynamically using adhesive weights:
- Press the
illuminates.
- Press the button twice to select "Motorcycle Alu" programme (the corresponding
balancing planes are highlighted on the rim shown on the control panel).
- Proceed as described previously for the "Motorcycle Dynamic" programme.
- For the application of the adhesive weight, use 3 o'clock as a reference if the "H3" con-
figuration is active, 6 o'clock if the "H6" configuration is active or 12 o'clock if the "H12"
configuration is active.
Best results can be achieved if the adhesive weights are positioned with the outer edge
flush with the rim edge.
Weight Division programme (available only with motorcycle programmes)
Some rims have spokes so wide that it is not possible to place adhesive weights next to
them; a programme which divides the counterweights into two parts has been introduced
to solve this problem.
In this case, when the centred position is reached and it becomes obvious that the bal-
ancing weight will have to be applied in line with a spoke, proceed as follows:
- Remain in the centred position.
- Press .
- Use the
• 1 = small
• 2 = medium
• 3 = large
• OFF = deactivates the programme
- Confirm with the
- Apply two new counterweights in the positions indicated.
In "ALU MOTO" and "dynamic" modes it is possible to divide the balancing weights over
both sides of the wheel to be balanced.
90
Motorcycle ALU programme
keys until the LED corresponding to the programme
keys to select the width of the spoke:
key.
EM 7240 Operator's manual