Corghi EM 7240 Manuel D'utilisation page 60

Installing the wheel guard with the corresponding mounting (Fig. 4)
- Install the bush (A, fig. 4) on the pivot (B, fig. 4). While doing this, ensure that the groove
on the pivot is aligned with the pin in the bush;
- Fasten the tube on the pivot using the M12 screw supplied.
- Insert the metal tube (D, Fig. 4a) into the two plastic guard front holes (C, Fig. 4a).
- Couple the guard to the rear side of the tube by inserting it into the correct position
with snap-in coupling (E, Fig. 4a).
- Secure the wheel guard by tightening the screw provided (F, Fig. 4a).
60
4
EM 7240 Operator's manual
4a