Corghi EM 7240 Manuel D'utilisation page 76

- Press the button to confirm the previous value and set the machine for diameter
data entry.
- Read the rated rim diameter value on the tyre.
- Modify the displayed diameter value by pressing the
number is set. The diameter can be set in millimetres or the values already set can be
converted from inches to millimetres by pressing the
- Press the button to confirm the previous value and set the machine for distance
data entry.
- Bring the distance measuring arm into contact with the inner side of the rim (Fig. 10/10a).
- Read the distance value between the wheel and the body on the rule (A, Fig.11b).
- Modify the displayed distance value by pressing the
number is set.
- On completion, press
of the new dimensions, or
76
to display the unbalance values recalculated on the basis
to perform a wheel spin.
buttons until the read
button for five seconds.
11b
buttons until the read
EM 7240 Operator's manual