Sony UPX-DP10 Mode D'emploi page 55

5
Set the POWER switch on the camera to ON.
6
Set the PLAY/CAMERA switch to PLAY.
7
Select a picture to be printed with the mode button.
For details on selecting a picture, see "Viewing a Picture."
8
Press the PRINT button on the station.
The POWER/BUSY lamp on the station blinks in red. The message
"TRANSFER IMAGE..." is displayed on the LCD of the station.
While this message is displayed, the camera's LCD is turned off, and
when image transfer is finished, the LCD is automatically turned on
again. Be sure not to remove the camera from the station while this
message is displayed.
After the image data are transferred from the camera to the station, the
POWER/BUSY lamp of the station lights in red, and the message
"PROCESSING IMAGE..." is displayed.
The printing will be completed in about two and a half minutes.
When finished printing
Set the POWER switch on the camera to OFF to save battery power.
To turn the station and printer off
1
Disconnect the AC power adaptor of the station from wall outlet.
2
Press the POWER button on the printer to turn the printer OFF.
If the printer will not be used for an extended period of time
Remove the paper supply/eject tray from the printer and store it in the tray
case, turn off the printer, and then unplug the power cord.
55