Sony UPX-DP10 Mode D'emploi page 27

Setting power save mode
In power save mode, the camera is automatically set to the status equal to
power off after 3 minutes has passed with no operation.
1
When the SET UP display is shown on the LCD, press B of the mode
button so that the select mark points to POWER SAVE, then press
SET of the mode button.
The POWER SAVE ON/OFF display appears.
POWER
SAVE
ON OFF
2
Press b or B of the mode button to select ON, then press SET of the
mode button.
Power save mode is set.
To cancel power save mode
Select OFF in step 2 above, then press SET of the mode button.
To restore the camera from power save mode
In CAMERA mode: Press the shutter button halfway or turn off and on
the POWER switch.
In PLAY mode: Turn off and on the POWER switch.
1 Tips
When the camera is in power save mode, a print attempt from the station
results in either of the following messages on the station LCD: "SET
CAMERA" or "REPRINT OK [EXEC]/CANCEL [MENU]." The former
message is shown when no picture data has been sent to the station. The
latter message is shown when any picture data remains. Then, the camera
exits power save mode. Press the PRINT button again if a new picture has
been selected on the camera.
When the "REPRINT OK [EXEC]/CANCEL [MENU]" message is
shown, press the MENU button to restore the normal status before pressing
the PRINT button again.
27